Hi there ..

I'm trying to work out if I can perform a Young's Slits experiment where I use natural light, but put a filter either over a camera or the slit while I take a photo of the interference pattern created by the slits on a large surface. Are there any filters which use visible light but narrow the spectrum down to a "single" wavelength?

Hope you can help!

Ros

Perhaps Edmund Optics
http://www.edmundoptics.com/onlinecatalog/...ryid=41&level=2
Hope this helps
Marc

Fantastic thank you.

Ros

You will need to do more than just extract a monochromatic light source from your natural light (which you could do not only with a filter but also by placing a slit in the right spot at the output of a prism or diffraction grating). You'll also need to get a decent amount of phase coherence between the beams hitting each slit. You may need to first pass the light through a narrow pinhole (to get light that is mostly of the same phase across the dimensions of this small aperture), focus the output into a narrow beam and split the beam to direct a beam to each slit (Young used a thin card to do this). Even so, your pattern will not be as defined as if you'd used the output of a laser.

David